These units can be programmed to put in as little or as much detergent as the customer requires consistently.

Gives the user control of the chemical dosage and ensures cleaning quality consistency. By fitting the Auto dispenser the customer is in control of the wash quality, allowing the introduction of quality procedures for pre-soaking, manual washing and ultrasonic cleaning.

Installation

Our office, will contact the customer to organise a convenient fitting time and date. The customer is responsible for giving the engineer the fill level details, to enable the engineer to set the pump with the correct dilution rate.

Before the dispenser can be fitted, the customer will need to calculate the quantity of water they require in the sink to clean their surgical instruments. Usually, this level is determined by the level at which the instruments are fully submerged just below the water line. When the level has been agreed a permanent fill line needs to be established. This can be marked either with waterproof tape, a permanent marker or engraved into a stainless steel sink. Using the information supplied by the customer, the engineer can calculate the required dosage to set the pump.

e.g. 30 Litres of Water = 120ml of Endozime AW Plus @ 4ml per Litre

Personalised laminated instructions are supplied with each dispenser pump for the customer to put on the wall near the unit.